Metro Vancouver & Fraser Valley · Licensed Installers · Free Estimates
Epoxy Flooring Near Me in Metro Vancouver
Epoxy flooring near me starts with a free on-site estimate from FraserPlus Epoxy — licensed installers covering Vancouver, Burnaby, Surrey, Coquitlam, Langley, and 11 other Metro Vancouver and Fraser Valley cities. Garage floors, commercial epoxy, metallic finishes, and polished concrete.
Why Metro Vancouver Floors Need a System Built for BC
Concrete floors in Metro Vancouver face conditions that most epoxy suppliers don’t design around. The wet season — October through March, when Pacific moisture drives ambient humidity above 80% — is when most DIY and under-spec’d installations fail. Epoxy applied to a slab with elevated moisture vapor emission will delaminate within 12 to 24 months, regardless of the product’s stated coverage. The fix is not a better epoxy; it’s a moisture-vapor barrier primer applied after a calcium chloride test (ASTM F1869) confirms the slab’s emission rate is within safe range.
Garage floors in Surrey, Langley, and Burnaby carry a second risk that coastal contractors understand: road salt. The municipal road-salting programs across the Lower Mainland mean garage slabs absorb chloride from tire contact, and chloride contamination is invisible until the next coating peels at the line where the car idles. FraserPlus diamond-grinds every floor to remove the contaminated surface layer and uses a 100% solids epoxy — not a diluted waterborne system — that does not shrink into the pores during cure. The result is a floor that bonds to the slab rather than sitting on top of it.
A third factor is UV exposure. A garage with an east- or south-facing door open for several hours each day receives direct sun. Standard aromatic epoxy top coats yellow and chalk within two to three years under direct light. FraserPlus finishes every floor with a UV-stable polyaspartic top coat that does not amber regardless of light exposure — so the floor looks the same in year ten as it did the week of installation.
Epoxy Flooring Services Near You
Garage Floor Epoxy
100% solids epoxy base with vinyl flake broadcast and UV-stable polyaspartic topcoat. Hot-tire rated, road-salt resistant, and built for Metro Vancouver’s wet season. One to two-day residential installs available.
Commercial Epoxy Flooring
High-build epoxy systems for warehouses, showrooms, auto shops, breweries, and commercial kitchens. Phased installs, overnight scheduling, and CSA-rated slip-resistant finishes for facilities that cannot close during installation.
Metallic & Decorative Epoxy
Hand-troweled pearlescent metallic and full-broadcast vinyl flake systems for luxury garages, basements, and hospitality spaces. Custom colour blends sampled before install. Sealed under the same chemical-resistant topcoat used on commercial floors.
Polished Concrete
Seven-stage diamond grinding, lithium silicate densification, and a LEED-contributing finish to 400, 800, or 1500 grit. The durable option for sound slabs in retail, showroom, and commercial settings where the existing slab suits a polish.
What Does Epoxy Flooring Cost Near Me? (2026 Metro Vancouver Rates)
The table below shows 2026 Metro Vancouver market rates from CHBA BC regional data — not FraserPlus pricing. Actual quotes depend on floor condition, square footage, and system selected. Crack repair, moisture mitigation, and decorative upgrades add to cost where needed.
| Floor Type | Typical Size | Market Rate (2026) | Estimated Total |
|---|---|---|---|
| Residential Garage (standard) | 300–600 sq ft | $5–$8/sq ft | $1,500–$4,800 |
| Commercial Floor | 1,000–5,000 sq ft | $4–$7/sq ft | $4,000–$35,000 |
| Metallic / Decorative Epoxy | 200–800 sq ft | $8–$14/sq ft | $1,600–$11,200 |
| Polished Concrete | 500–5,000 sq ft | $4–$7/sq ft | $2,000–$35,000 |
Figures reflect 2026 Metro Vancouver market rates (source: CHBA BC). Excludes significant crack repair and moisture remediation costs. These are market benchmarks, not FraserPlus pricing.
How FraserPlus Installs Epoxy Flooring Near You
Free On-Site Estimate
We assess floor condition, run a moisture test, and confirm the right system for your space. No guesswork from photos.
Diamond Grinding
Concrete ground to a CSP-2/3 profile — the open texture epoxy needs to bond mechanically to the slab.
Crack & Moisture Prep
Active cracks filled and ground flush. Vapor barrier primer added if moisture readings exceed safe levels.
Epoxy Base Coat
100% solids epoxy primer coat — zero solvent, zero shrinkage — rolled into the open concrete profile.
Topcoat & Cure
UV-stable polyaspartic topcoat sealed over the design layer. Walkable same evening; vehicle-ready in 24 hours.
Licensed. Insured. Backed by a Workmanship Warranty.
Every FraserPlus install carries full commercial general liability insurance and WorkSafeBC coverage.
Licensed & Insured
Full commercial general liability insurance and WorkSafeBC coverage on every job site — residential or commercial.
100% Solids Epoxy Only
We don’t install waterborne or diluted systems. Every floor uses a professional-grade 100% solids epoxy base — the formulation behind the 15–20 year service life.
Workmanship Warranty
Adhesion failures caused by installation defects are covered. If the floor delaminates due to preparation or application error, FraserPlus fixes it at no charge.
Epoxy Flooring Near Me — Common Questions
How much does epoxy flooring cost near me in Metro Vancouver?
Residential epoxy flooring in Metro Vancouver typically runs $5–$8 per square foot for standard garage installations. A 400 sq ft two-car garage runs $2,000–$3,200 for a standard 100% solids epoxy with color-flake broadcast and polyaspartic topcoat. Commercial floors average $4–$7/sq ft; metallic and decorative systems start around $8/sq ft, ranging up to $14/sq ft for custom metallic pours. These are 2026 Metro Vancouver market rates — not FraserPlus pricing. Surface grinding, crack repair, and moisture mitigation add to cost where needed. Source: CHBA BC regional construction cost benchmarks.
How long does epoxy flooring installation take?
A standard two-car garage (400–600 sq ft) takes two to three days: one day for diamond grinding and surface prep, one to two days for primer coat, base coat, decorative flake broadcast, and polyaspartic topcoat. Single-car garages can complete in one to two days. Commercial floors are staged by zone to keep the facility operational. BC’s wet season (October through March) extends cure times — humidity above 85% or concrete below 10°C slows adhesion. FraserPlus applies a moisture-barrier primer to manage Vancouver’s ambient humidity before any coating goes down.
What types of epoxy flooring are available near me?
FraserPlus installs five main systems across Metro Vancouver: (1) 100% solids epoxy with color-flake broadcast — the standard residential garage choice; (2) metallic epoxy — hand-troweled pearlescent pigment for luxury interiors; (3) polyaspartic coating — UV-stable, fast-cure, used as a topcoat or standalone system; (4) quartz-broadcast for high-traffic commercial floors requiring anti-slip texture; (5) polished concrete where the existing slab suits a ground-and-polish finish without a resin coating. All systems include a diamond-grind surface prep, crack repair, and moisture assessment at the estimate.
How do I prepare my concrete floor for epoxy coating?
Proper surface preparation is the primary factor in long-term adhesion. Concrete must be diamond-ground to open the pores — acid etching alone is no longer a professional standard for bonded coatings. Active cracks need repair before coating. Moisture is the most common failure point: vapor emission should be below 5 lbs per 1,000 sq ft per 24 hours (ASTM F1869); higher readings require a moisture-vapor barrier primer. Oil contamination in garage slabs — common across Metro Vancouver — needs degreaser treatment followed by mechanical grinding before primer can bond. FraserPlus includes a moisture test and floor condition assessment with every free estimate.
Is epoxy flooring durable in BC’s wet climate?
Yes, when the right system is selected for BC conditions. Metro Vancouver garages face specific challenges: hot-tire staining (plasticizers in rubber bond to some epoxy formulations), de-icing salt from road salting programs in Surrey, Burnaby, and Langley, and the wet-to-dry cycle from Pacific storms. 100% solids epoxy is substantially more chemical- and abrasion-resistant than the 50% or 65% solids systems sold at hardware stores. A polyaspartic topcoat seals the surface, resists UV yellowing under garage window light, and is hot-tire rated. Properly installed systems last 15–25 years in residential garage use.
Which Metro Vancouver areas do you serve near me?
FraserPlus Epoxy serves all of Metro Vancouver and the Fraser Valley: Vancouver, Burnaby, Surrey, Coquitlam, Port Coquitlam, New Westminster, Delta, Richmond, Langley, Maple Ridge, West Vancouver, and North Vancouver. We also cover the Fraser Valley corridor, including Abbotsford and Mission for commercial projects. Residential estimates are typically scheduled within 48 hours. Free in-home estimates with no travel charges within the service area. Call 778-952-0221 to confirm availability in your city.
Ready to Get Epoxy Flooring Near You?
FraserPlus Epoxy schedules free on-site estimates within 48 hours across Metro Vancouver and the Fraser Valley. We confirm your floor’s moisture level, crack condition, and the right system before quoting — no surprises on install day.
Book a Free EstimateOr call us directly: 778-952-0221